Page 46 - CHROMA ELITE PAINT

PREVIOUSLY PAINTED SURFACES:

Wash to remove contaminants. Rinse thoroughly with water and allow to dry.

Sanding not required if the surface is properly and thoroughly cleaned (scuff
sanding is required only on glossy, hard, slick or dense surfaces which are subject
to high levels of moisture). Remove loose paint. Scrub heavy chalk areas and

overhead areas such as eaves with soap and water. Rinse surfaces clean with water
and allow to dry for 24 hours. Prime bare areas with primer specified under NEW
SURFACES.

APPLICATION PROCEDURE:

Mix thoroughly before use. May be applied by brush, roller or spray. No thinning
required. Effectively seals most water stains, inks, crayon, ballpoint pen marks,
lipstick, bleeding paints, knots, sap streaks, tobacco, nicotine stains. Some stains
may require a second coat. Some highly sensitive stains may require the

application of a solvent-based stain sealer for best results. For exterior
applications, stop painting at least two hours before you expect heavy dew, rain or
temperatures below 45℉ (7℃). For maximum stain resistance, allow four hours

before top coating. Low temperature, high humidity, thick films or poor
ventilation will increase these times. Airless Sprayers: Use at least a 1 gallon per
minute piston type airless sprayer with a minimum tip size of .017. Remove all line
filters and gun filters before spraying.

CLEAN UP:

Clean up all spills, tools and overspray immediately while the coating is still wet
with warm soapy water.

NOTE:
SUPER BLOCK™ will not hide stains completely by itself. Once a paint or coating
is applied, the stain or blemish should be noticeably sealed. If stains persist, the

application of a solvent-based stain sealer may be necessary.

813-841-9462 sales@chromaelite.com