Page 42 - CHROMA ELITE PAINT
P. 42

Apply only to a sound, completely dry, well prepared roof surface. Leaks
      must be repaired before any coating is applied. Prepare surface by thoroughly

      pressure washing with a water and chlorine mixture using at least 1500 P.S.I.

      to remove any previous coatings, dirt, grease, and other foreign materials,
      especially mold, mildew and algae. METAL-PRIME RED  will resist mildew

      growth, but will not kill mildew already on the surface. Apply METAL-

      PRIME RED in rusted or corroded areas that need to be treated. TWO
      COATS OF METAL-PRIME RED MUST ALWAYS BE APPLIED. Patch

      any holes, cracks, flashings, valleys, vents, etc., with
      PERMAPATCH™ Elastomeric Patching Compound, a Waterproof Caulk and

      Sealant, after METAL-PRIME RED  application. Tape & seal all seams
      with TAPE PERMA, a Polyester Fabric Tape or STIKPERMA Butyl Tape.

      NOTE: METAL-PRIME RED-Rusted Metal Primer Sealer may be used as a

      saturant for the TAPE PERMA with the second coat of METAL-PRIME RED
      applied over the TAPE PERMA.


      APPLICATION PROCEDURE:

      Stir well. You will notice METAL-PRIME RED to be quite thick. This is
      necessary to hold the high solids of zinc and red iron oxide pigments in

      suspension. If thinning is necessary, use water sparingly, not exceeding 8

      ounces per gallon of primer. Be sure to only thin the amount of product that
      will be used within 24 hours, or settling of pigments may occur. If possible,

      METAL-PRIME RED should be applied as is from the container, no thinning.

      Apply at temperatures above 40℉ and when primer will not be subjected to
      rain or heavy dew before it has had a chance to dry (approximately 2-4 hours).

      Apply with short nap roller, brush or at least a 1 gallon per minute piston type
      airless sprayer with a minimum tip size of .027. Apply uniformly and do not

      leave any puddles. Two coats are required. The first coat may show some
      flash rusting, but the second coat will completely encapsulate all active

      oxidation. Spot priming is acceptable, but the applicator should be aware of

      the possibility of microscopic rust not visibly seen. Spot prime with two coats
      of METAL-PRIME RED and extend one foot beyond the perimeter of the
   37   38   39   40   41   42   43   44   45   46   47